Sökresultat

Direct conversion receivers are widely used for full duplex mobile radio communication systems. This paper describes a novel SAW-less single-ended RF amplifier connected to a single-ended mixer with a feedback loop that suppresses the second-order distortion from TX cross modulation of the LO-leakage as well as DC-offset at the mixer output. In Monte Carlo simulations the design achieves +47 dBm m

TO-DCF, a new backoff scheme for 802.11, has the potential to significantly increase throughput in dense wireless LANs while also opportunistically favouring nodes with heavier traffic loads and/or better channel conditions. In this paper we present an analytical model to investigate the behaviour and performance of the TO-DCF protocol with regards to operating parameters such as the number of nod

We present a high performance low-power digital base-band architecture, specially designed for an energy optimized duty-cycled wake-up receiver scheme. Based on a careful wake-up beacon design, a structured wake-up beacon detection technique leads to an architecture that compensates for the implementation loss of a low-power wake-up receiver front-end at low energy and area costs. Design parameter

Requirements Engineering has recently been greatly influenced by the way how firms use Open Source Software (OSS) and Software Ecosystems (SECOs) as a part of their product development and business models. This is further emphasized by the paradigm of Open Innovation, which highlights how firms should strive to use both internal and external resources to advance their internal innovation and techn

This paper presents preliminary results for a novel 128-antenna massive Multiple-Input, Multiple-Output (MIMO) testbed developed through Bristol Is Open in collaboration with National Instruments and Lund University. We believe that the results presented here validate the adoption of massive MIMO as a key enabling technology for 5G and pave the way for further pragmatic research by the massive MIM

This paper presents an adaptive QR decomposition (QRD) processor for five-band carrier aggregated LTE-Adownlinks. The design uses time and frequency correlationproperties of wireless channels to reduce QRD computationswhile maintaining an uncoded bit error rate loss below 1 dB.An analysis on the performance of a linear interpolating QRD ispresented and optimum distances for different channel condi

In this paper an implementation of a reduced complexity matching pursuit channel estimator for LTE is presented. The design contains an FFT/IFFT module with non-radix 2 units and the core estimator. The FFT/IFFT module is flexible enough to perform both operations using the same hardware. Based on prior work the needed internal word lengths are found. Internal shifts are employed to maximize the u

Multiple-input multiple-output (MIMO) is a key enabler for high data rates in mobile communications. However, it is challenging to design MIMO terminal antennas for LTE bands below 1 GHz, due to the conventional chassis offering only one resonant characteristic mode (CM). Recently, it was shown that minor structural changes can yield up to two additional resonant modes for designing two-port MIMO

Unfair work distribution is common in project-based learning with teams of students. One contributing factor is that students are differently skilled developers. To mitigate the differences in a course with group work, we introduced mandatory programming lab sessions. The intervention did not affect the work distribution, showing that more is needed to balance the workload. Contrary to our goal, t

Software design in e-commerce can be improved with user data through controlled experiments (i.e. A/B tests) to better meet user needs. Machine learning-based algorithmic optimization techniques extends the approach to large number of variables to personalize software to different user needs. So far the optimization techniques has only been applied to optimize software of low complexity, such as c

Running regression tests for Modelica models usually takes a long time. This paper presents a safe regression test selection technique for Modelica based on static analysis. The technique tracks dependencies between classes to compute which tests that need to be run given a change. The dependency rules have been verified using mutation testing. The technique has been evaluated on the Modelica Stan

Just like current software systems, models are characterised by increasing complexity and rate of change. Yet, these models only become useful if they can be continuously evaluated and validated. To achieve sufficiently low response times for large models, incremental analysis is required. Reference Attribute Grammars (RAGs) offer mechanisms to perform an incremental analysis efficiently using dyn

Massive multiple-input multiple-output (MIMO) is one of the key candidates for the upcoming 5G wireless generation. It offers a multitude of advantages over traditional techniques, such as reduced latency, reduced interference among user equipments (UEs) and increased spectrum and energy efficiencies. However, to verify the theoretically promised gains in real-life, prototype systems are inevitabl

This paper presents a multi-bit, continuous time delta-sigma modulator with 20 MHz bandwidth implemented in 65nm CMOS for cellular communication. The modulator features a third order, single loop filter and a 4-bit internal quantizer operating at 640 MHz. The DACs are resistive for lower thermal noise compared to the current-steering DACs and nonreturn-to-zero DAC pulse is used to reduce the clock

A large ensemble of regional climate model projections was investigated regarding if and when they show an emergence of significant climate change signals in seasonal temperature and precipitation within Europe. The influence of the North Atlantic Oscillation (NAO), as simulated in the projections, was investigated. In most parts of Europe, the projections indicate robust emergence of temperature

In this paper a synchronized dual input-channel multi-mode Software Defined Radio receiver platform that we built originally is presented. The receiver platform compatible with the GSM, WCDMA, and Wi-Fi standards can detect and identify the surrounding base stations and access points. It features wide frequency range, high adaptive sampling rate and especially dual phase coherent receiving channel

The purpose of the risk management process, RiskUse is to provide practitioners, mainly risk managers with a software risk management process that has a well-defined user perspective. The aim is to present a risk management process that allows the development organisation to perform adequate risk management activities that can ensure that the developed software is safe from a user perspective.