Filtyp
OBJECTIVE: To increase the understanding of how definitions of standards for housing design influence the proportion of dwellings not meeting the standards and the proportion of individuals defined as having accessibility problems. METHODS: The sample included old people and their dwellings in three European countries (N = 1,150). Frequencies and percentages were reported and empirical distributio
A modified heat-moisture exchanger that incorporates a reflecting filter for use with partial rebreathing of exhaled volatile anaesthetics has been commercially available since the 1990s. The main advantages of the device are efficient delivery of inhaled sedation to intensive care patients and reduced anaesthetic consumption during anaesthesia. However, elevated arterial CO2 values have been obse
The feasibility of temperature and concentration measurements using near-IR (similar to 1.5 mu m) water spectra obtained by fiber laser intracavity spectroscopy was evaluated. The spectra were registered with water vapor heated in a tubular oven at temperatures between 1000 and 1300 K and in adiabatic flames where temperatures were above 1800 K. Adiabatic flames of methane were stabilized on the h
This paper presents a model that can calculate the uptake of CO2 in all existing concrete structures, including its uptake after service life. This is important for the calculation of the total CO2 uptake in the society and its time dependence. The model uses the well-documented cement use and knowledge of how the investments are distributed throughout the building sector to estimate the stock of
To estimate current and future avoidable smoking-attributable costs in Sweden for the year 2007.
This study compares two approaches to the estimation of social welfare intervention costs: one "top-down" and the other "bottom-up" for a group of social welfare clients with severe problem behavior participating in a randomized trial. Intervention costs ranging over a two-year period were compared by intervention category (foster care placement, institutional placement, mentorship services, indiv
We present the first method to handle curvature regularity in region-based image segmentation and inpainting that is independent of initialization. To this end we start from a new formulation of length-based optimization schemes, based on surface continuation constraints, and discuss the connections to existing schemes. The formulation is based on a cell complex and considers basic regions and bou
A case-control study compared 129 men with earlier partial gastrectomy (operation during the period 1952-1961) with 216 men from a community-based population study. All were born 1910-1915 and the mean age was 72 years. Men with a previous partial gastrectomy had vertebral fractures in 19% compared with 4% (P < 0.01) in the control population. Bone mineral density (BMD) in the right calcaneus meas
This thesis deals with the development of simultaneous saccharification and fermentation (SSF) in order to improve the economy of the softwood-to-ethanol process. The effect of process stream recirculation on ethanol production from steam-pretreated softwood based on SSF was investigated for two process cases. In the first case, part of the stillage stream after distillation was recycled and in th
This paper derives a generic model for the multiple-input multiple-output (MIMO) wireless channel. The model incorporates important effects, including i) interdependency of directions-of-arrival and directions-of-departure, ii) large delay and angle dispersion by propagation via far clusters, and iii) rank reduction of the transfer function matrix. We propose a geometry-based model that includes t
Abstract is not available
Hosts can in principle employ two different strategies to defend themselves against parasites: resistance and tolerance. Animals typically exhibit considerable genetic variation for resistance (the ability to limit parasite burden). However, little is known about whether animals can evolve tolerance (the ability to limit the damage caused by a given parasite burden). Using rodent malaria in labora
The objective of this paper is to investigate how the combustion chamber design will influence combustion parameters and emissions in a natural gas SI engine. Ten different geometries were tried on a converted Volvo TD102 engine. For the different combustion chambers emissions and the pressure in the cylinder have been measured. The pressure in the cylinder was then used in a one-zone heat-releas
Thermal radiation sometimes is the dominating heat transfer mode in combustion chambers and furnaces and therefore in the design of many relevant industrial facilities prediction of it is necessary. During previous years many research efforts in the radiative heat transfer field have originated and many methods and models from simple to complex have been developed. However, the field is still open
The basic ideas of k(t)-factorization and CCFM parton evolution is discussed. The unintegrated gluon densities, obtained from CCFM fits to the proton structure function data at HERA are used to predict hadronic final state cross-sections like jet production at HERA, but also comparisons with recent measurements of heavy quark production at the Tevatron are presented. Finally, the k(t)-factorizatio
New strategies for prevention and treatment of type 2 diabetes (T2D) require improved insight into disease etiology. We analyzed 386,731 common single-nucleotide polymorphisms (SNPs) in 1464 patients with T2D and 1467 matched controls, each characterized for measures of glucose metabolism, lipids, obesity, and blood pressure. With collaborators (FUSION and WTCCC/UKT2D), we identified and confirmed
A non-associated plasticity theory for granular materials has been developed in Part 1 based on the concept of a characteristic stress state of vanishing incremental dilation. The model is fully three-dimensional and is defined by six material parameters: two for elastic stiffness, one for plastic stiffness, two for the shapes of yield and plastic potential surfaces and one for the dilation at fai
